Jim Strickland
2013-10-13 04:38:11 UTC
I was reading the group last night and stumbled across a discussion about stackable headers for the Zeta 26 pin parallel port, in reference to adding another card under the para-prop board. I wondered if this, sourced for the Raspberry Pi's 26 pin header and seemingly compatible with the soldering holes in my Zeta boards, would solve that problem?
http://www.adafruit.com/products/1112
-JRS
http://www.adafruit.com/products/1112
-JRS
--
You received this message because you are subscribed to the Google Groups "N8VEM" group.
To unsubscribe from this group and stop receiving emails from it, send an email to n8vem+unsubscribe-/JYPxA39Uh5TLH3MbocFF+G/***@public.gmane.org
To post to this group, send email to n8vem-/JYPxA39Uh5TLH3MbocFF+G/***@public.gmane.org
Visit this group at http://groups.google.com/group/n8vem.
For more options, visit https://groups.google.com/groups/opt_out.
You received this message because you are subscribed to the Google Groups "N8VEM" group.
To unsubscribe from this group and stop receiving emails from it, send an email to n8vem+unsubscribe-/JYPxA39Uh5TLH3MbocFF+G/***@public.gmane.org
To post to this group, send email to n8vem-/JYPxA39Uh5TLH3MbocFF+G/***@public.gmane.org
Visit this group at http://groups.google.com/group/n8vem.
For more options, visit https://groups.google.com/groups/opt_out.